×

Loading...
Ad by
  • 推荐 OXIO 加拿大高速网络,最低月费仅$40. 使用推荐码 RCR37MB 可获得一个月的免费服务
Ad by
  • 推荐 OXIO 加拿大高速网络,最低月费仅$40. 使用推荐码 RCR37MB 可获得一个月的免费服务

@

没有单独的fuse控制。按照链接中的说明,disconnected the cable of the sensor that was used for the hood latch,彻底解决了这个问题。四个门的防盗仍然起作用,仅仅是去掉了车头盖的防盗而已。

After months of having the random alarm issue on my ‘04 TSX, IT IS FINALLY FIXED. (posting this everywhere so those in similar situations can fix it the easiest way).

My factory alarm began going off for no reason and I tried the easy fixes first. It was not due to low batteries on my key fobs, or a depleted car battery, or any issue with the doors/trunk. It was narrowed down to the hood latch sensor. Acura dealership claimed there is no way to disconnect the sensor, but there absolutely is and it’s fairly straightforward. Before you take your car to a mechanic, attempt to clean the sensor, or even buy a new hood latch assembly, please TRY THIS:

1. Open the hood, and remove the black covering near the hood latch (the one with all the black clips).
2. Remove the grill held in by similar clips (2 on top, 4 on bottom) ((this step may not be necessary, but allows much easier access))
3. Remove the black casing around the latch assembly (3 bolts)
4. From here, you will see 2 grey wire connectors towards the bottom of the latch assembly. Disconnect by pinching down on the right connector and pulling apart. (I covered up these connectors with electrical tape just to be safe).
5. If the connectors aren’t visible from that point, you may have to remove the actual lock assembly. Just 3 more bolts, not difficult.

After reassembling the car, my random alarm issue ceases to exist. My alarm system still works with the 4 doors and my trunk, just not my hood. This was the easiest, cheapest, and best possible outcome I could have asked for.

Report

Replies, comments and Discussions:

  • 枫下家园 / 我爱我车 / 求救:2006 Acura CSX的报警器经常自动鸣叫,开关车门,移动车后暂停,但十几分钟又开始鸣叫,最后把车头盖打开才完全停止,请问如何解决?老车不需要警报,可以disable掉吗?
    • 看看 fuse box
    • 你要确定是原厂的还是加装的。加装的需要找车行拆掉,原厂的你遥控开锁后,不会再响。
    • 打开车头,找到警报器,喇叭的位置,一般是独立供电的,拔掉插头;如果不是独立供电,那么就把整个报警器的电源拔掉。如果是原厂的,打开你的保险盒,它的背面有识别图,找到警报的位置,拔掉fuse,然后用胶布贴到一个安全的位置。done。 +1
      • 一般保险盒盖子都留着几个备用保险,插哪儿就成
        • 那是10年以前,而且还有一个夹子。现在的车基本都木有了。就一个盖子。 +1
          • 楼主不是2006的车 +2
      • 非常感谢,我找了fuse box的示意图,见链接,没看到哪个是用于警报的,请问应该拔掉哪一个保险? +1
        Passenger Compartment Fuse Box The interior fuse box is on the driver’s lower left side. (1 - Fuse label) No. A Protected Component 1 7.5 Power Mirror Switch Light, Power Window Relay 2 15 Fuel Pump, ECM/PCM, Immobilizer-Keyless Control Unit 3 10 Alternator, CMP Sensor A, ECM/PCM, ELD,
        • 一个个拔过去,总有一个是
    • 没有单独的fuse控制。按照链接中的说明,disconnected the cable of the sensor that was used for the hood latch,彻底解决了这个问题。四个门的防盗仍然起作用,仅仅是去掉了车头盖的防盗而已。
      After months of having the random alarm issue on my ‘04 TSX, IT IS FINALLY FIXED. (posting this everywhere so those in similar situations can fix it the easiest way).

      My factory alarm began going off for no reason and I tried the easy fixes first. It was not due to low batteries on my key fobs, or a depleted car battery, or any issue with the doors/trunk. It was narrowed down to the hood latch sensor. Acura dealership claimed there is no way to disconnect the sensor, but there absolutely is and it’s fairly straightforward. Before you take your car to a mechanic, attempt to clean the sensor, or even buy a new hood latch assembly, please TRY THIS:

      1. Open the hood, and remove the black covering near the hood latch (the one with all the black clips).
      2. Remove the grill held in by similar clips (2 on top, 4 on bottom) ((this step may not be necessary, but allows much easier access))
      3. Remove the black casing around the latch assembly (3 bolts)
      4. From here, you will see 2 grey wire connectors towards the bottom of the latch assembly. Disconnect by pinching down on the right connector and pulling apart. (I covered up these connectors with electrical tape just to be safe).
      5. If the connectors aren’t visible from that point, you may have to remove the actual lock assembly. Just 3 more bolts, not difficult.

      After reassembling the car, my random alarm issue ceases to exist. My alarm system still works with the 4 doors and my trunk, just not my hood. This was the easiest, cheapest, and best possible outcome I could have asked for.

    • 就是hood latch开关坏掉了,要么拔线,要么跨接。很容易的事。 +1
      • 实际情况是,hood latch里的一个金属挡片有问题,当车头盖关上时,正常情况下该金属挡片受重力压迫,应该向下移动顶住防盗按钮以触发sensor。但现在其有点变形,无法顶住sensor,导致锁车后警报鸣叫。拔掉sensor cable后,hood latch还是可以正常锁住车头盖。
    • 前阶段邻居有个车也是这样,是租户的车。不知道是怎么解决了,是挺烦人的。