This topic has been archived. It cannot be replied.
-
工作学习 / IT杂谈 / 请教一个网络问题我现在家里有一个从ROUTER分出来的ROGERS HIGHSPEED的插头。可以一台机器上网。我想第二台机器也上网并且两台机器可以相互访问。什么方法最好？
-sunnyhoo(sunny);
2003-5-21
{134}
(#1198619@0)
-
买一条网线连接你的router和另一台PC，在Router上配DHCP
-pasu(InTheSky);
2003-5-21
(#1198620@0)
-
由于ROUTER不由我控制，我是否可以买一个HUB，将ROUTER出来的插头接到HUB上，然后由HUB份出两条线呢？
-sunnyhoo(sunny);
2003-5-21
(#1198859@0)
-
most of time YES, but check router manual first
-mssg(mssg);
2003-5-21
(#1198890@0)
-
Buy a NIC and install it in your computer connected with the router, use a cross-talk cable to connect your 2 computer. Then configure 'internet connection share', OK!
-wjemail(yxz);
2003-5-23
(#1201825@0)
-
So the first computer will provide a 2nd layer NAT service?I have the same question, I have 2 NICs in my 1st computer which connect with a DHCP/Internet Sharing server, how to configure it if I want to connect a 2nd computer to the spare NIC through a cross-link cable.
the 2nd one still acts as a DHCP client?
-elac(elac);
2003-5-24
{252}
(#1202965@0)
-
与路由器相连的网卡从DHCP取地址，并将其连接设为共享；另一张网卡和另1台电脑采用固定分配的地址，如192.168.x.x,DNS设为路由器的IP地址即可。
-wjemail(yxz);
2003-5-24
(#1203837@0)
-
of course YES. But be careful the Switch Port, u should plug the cable to the Router to switch's uplink port
-su27(和稀泥);
2003-5-25
(#1204144@0)
-
买一个带uplink口的hub就行啦
-junhua(Henry);
2003-5-25
(#1204288@0)
-
Cannot be easier.
-workopolis(﹡ 枫树下の守望者 ﹡);
2003-5-21
(#1198625@0)